Online Manufacturer for EN 14399-4 and 8 Structural Bolt Set for Proloading for Surabaya Manufacturer

EMPHASIS ON DIY! A customer needed a quick frame patch on his 57 chevy, We didn’t have a good section of channel to just cut & weld in. So, I did it this way. If you dont care too terribly much about how it looks this is a fine method. Did this in a few hours. This is going to be a rat rod, so I like showing the hard lines of what I have done. I have also repaired frames with a formed channel being placed inside or outside the original frame- but that is more costly for the customer.

For more how to videos make sure to check out & subscribe to my channel!!

What to do when You shear off a bolt and need to drill it out, re tap and thread it. Worst case is the drill-bit breaks off and is stuck in bolt while trying to drill out the broken nut or bolt. Drill bit steel is extremely hard at 58-66 Rockwell so what drills out and removes a drill bit? Carbide tile cutter for Dremmel or Rotozip tools will fork to drill out a and remove a broken drill bit. Same applies for a broken tap. If you break a tap while trying to re tap and die threads A SHARP (Its must be a sharpened Bit like the blue granite bits from Bosch) carbide Masonry drill Will remove the hardened steel.
Please Click The Subscribe Button Below And Share Video With G+, Facebook, Twitter and all Your Favorite Social Media!
Comments and questions are encouraged but please be respectful.
Visit https://wayneslockshop.com/ For More tips and tricks for the Locksmith Industry

https://tricountylocksmithservice.com/

All views and opinions are the alleged interaction with any product shown and not a fact stated by Wayne Winton and or Tri County Locksmith Service. The information shown in any video is 100% opinion of Wayne Winton and protected by the 1st amendment, the freedom of speech. Some products may be provided by the company being reviewed and others are purchased independently by Wayne Winton, Tri County Locksmith Service. Either way it does not reflect the content of the review. All products are given a fair equal chance to perform. All videos are property of Wayne Winton and all rights are reserved. If you would like to post any video please contact Wayne Winton at: Tricountylocksmithservice@gmail.com for permission.
Disclaimer: Do not try this at home! Any content seen here is for entertainment only! Do Not try anything seen here yourself or there may be danger of bodily harm or legal consequences for your actions! Any illegal activity is prohibited and Wayne Winton and or Tri County Locksmith Service are not responsible for your actions!
Wayne Winton, © 2014. All rights reserved. Publication, reproduction or distribution of this film by any means whatsoever – including without limitation electronic transmission via internet or e-mail, or re-uploading existing videos & re-uploading such material on any website anywhere in the world — is strictly prohibited without the prior written consent of Wayne Winton. Please note that Wayne Winton, Tri County Locksmith Service does not state any confirmed facts only personal opinions. I am not directly affiliated with any of the vendors or manufacturers in this video. Wayne Winton, Tri County Locksmith Service is not liable for any damage or loss through the use of products or techniques shown – Use at your own risk! This film and the Wayne Winton, Tri County Locksmith Service film series broadcast on YouTube is intended for entertainment purposes only.
Tri County Locksmith Service
1338 Grand Ave
Glenwood Springs
Colorado
81601
970-945-5625 970-963-5625 970-922-5625