Cheap PriceList for Round Button Head Guardrail bolts to Madagascar Importers

Ultimate positioning accuracy can be obtained using the fine lead of the SKF Recirculating roller screws. Learn more at https://bit.ly/1eQ8pvJ

Related video:

The SKF Recirculating roller screws can simplify a complete transmission and improve its rigidity. Their great mechanical advantage minimizes input torque and increases resolution. They are often used in applications of advancing technology where reliable optimum performance is vital.

SKF is changing the world through the power of knowledge and engineering. SKF started in 1907 as a bearing company, but today we make everything from lubrication systems to mechatronics. You can find our products & solutions in almost anything that rolls or moves, from space shuttles to skateboards.

Visit us at https://www.skf.com.

Don’t forget to subscribe to our YouTube channel or like us on Facebook https://www.facebook.com/SKFGroup for daily updates.

Buy everything you see in these video’s here online Now:
Tub And Shower Faucet: https://go.magik.ly/ml/a583/
Extra cover plate: https://go.magik.ly/ml/a64f/
Moen Tub and shower cartridge: https://go.magik.ly/ml/a64a/
1/2 copper 90′s: https://go.magik.ly/ml/a64i/
1/2 Copper Streed 90′s: https://go.magik.ly/ml/a64l/
1/2 Brass wing 90: https://go.magik.ly/ml/a64o/
Gas and touch set: https://go.magik.ly/ml/a64q/
In this video we start by removing the old two handle tub and shower valve from inside the wall. First we remove the handles and spout leaving the shower head in place to hold up the old shower valve and keeping it there until the new shower valve is in place this makes it easy and keeps use inline with the new installation and makes it very easy to line up the new shower head. Now that we have the handle off its time to go around on the back side and cut into the wall or if were lucky there just may be a trap door on the back side that gives us access to the tub and shower valve from the back side. Once on the back side of the tub and shower valve we start by disconnecting the unions on the old two handle tub and shower valve. Now the part that goes up to the shower head is copper. What we are going to do here is take our torch and heat the solder connection and pull the valve loose from the shower head riser pipe. Now with the old tub and shower valve out the way lets go back to the front side in the bath room. Now this was a three handle tub and shower valve so were going to have to make some adjustments to the hole in the wall in this case we will have to open the middle hole a little wider for the new single handle tub and shower valve. This is not your standard drywall (sheetrock) wall this is old and very thick no cutting this with a saw saw. What were going to do here is use a hammer and just lightly knock out pieces of the wall slow and easy. Don’t worry about covering up the old holes they make a cover plate for that. We have the hole just how we won’t it lets go back to the other side behind the tub and shower. What I like to do is put my new tub and shower valve to gather and solder pieces in place before I start working in the wall with it and I also remove the washers in the valve so we don’t damage the washers with the hot torch and burn them up once all this is done I take the tub and shower valve and put it into place line it up and make all the necessary connections from the back side from here I go back to the front of the valve in that bath room and start putting all the trim on but installing the cover plate first then if you like caulk it. Thank you for watching coolplumbingvideos.

-~-~~-~~~-~~-~-
Please watch: “Pex Pipe Plumbing (The Complete Series)